Korg Forums

Hello. Can someone be kind enough to post a pic or at least direct me to the type plastic standoff for the PBS-TRI. I purchased a set used and it is on it's way but is not coming with the two little plastic standoffs. Thank you.

Mine is installed without the standoffs. The multi-pin connector holds it in place fairly well it and will likely be fine if you're not banging the board around too much.

Bach42t wrote:Hello. Can someone be kind enough to post a pic or at least direct me to the type plastic standoff for the PBS-TRI. I purchased a set used and it is on it's way but is not coming with the two little plastic standoffs. Thank you.

If I recall, they're about an inch high. NOt too sure, I sold my PBS and I had a really hard time unplucking those two little suckers. I was afraid to pull off too hard from the board, but they finally came out. Once they were out, I realized that they have the little head in the shape of an arrow, thats why it was hard to unpluck them. If you go to your local electronics store, they usually sell many sizes. If not check ebay. But like 3fingers said, you can still plug the board in and it wil hold just fine, but if you gig or are going to transport your board around, the platic standoffs, are a must. Good luck.

PS, EDit: You may check out TIMO's post about the PBS board I think there are some detailed pics there. He really helped me out when I was selling mine.

Hey thanks. I will probably just install without the plastic standoffs. I would bet since so many people have purchased theirs 2nd hand without the standoffs and never complained, then it's not going to be an issue. I am not going to be gigging with it and it will either spend more time back in her box until I need her or be on a stand sitting nicely. Thanks for the responses