Korg Forums

Today I received my V-stand for the Oasys. After I disconnected my cables and connected everything my O won't boot.

I get a blue screen which says:

"This Oasys must be re-authorized before it can be used. Please write down the Public-ID shown below and then go to the following website to begin the re-authorization: www. korgusernet

Public-ID:
unavailable

12 "


I didn't have any problems before. I use 1.3.3 with all the exi and expansions installed working fine.

Does anybody know what to do

Strange, after 4 times trying with no results the O booted the right way after an hour waiting.

To be sure it worked out I started the O again and it works fine

I don't understand what happened, but for now it is al working.....

Arend: That is weird! Might not be a bad idea to contact Korg service locally and see if they have an explanation for the glitch, even though it seems to be OK now. You would hate to have that issue if you moved it again. No way can you deal with that if you find it happening when you set up for a gig!

nitecrawler

Yes, a good advice. All the time my O was located on the same spot. First time in years I unplugged everything and then this terrible message appeared...but I rebooted three times again and nothing happened. I am bit scared to unplug all the cables again right now.....

Arend, I've had to reauthorize my OASYS, in the past. To do so, you call Korg Support and give them your ID number. They sent me an email with a link to the reauthorization. You make a boot disc out of it, just like an OS update, and then boot your OASYS with it.

In my case, Korg sent me the email within an hour of calling them. I burned the disc and was on my way.

Thanks Mike, I will contact the Local Korg support comming week so I am prepared if this will happen again.