How to load a Multi Sample on Korg M3

Anthony.karuna · Post by **Anthony.karuna** » Sat Mar 13, 2010 8:44 am

Can someone help me to load multi samples and convert that as a program on M3?

I was only able to load single samples and I wasn't able to take that anywhere but the Media page. Please help!

kid_nepro_2002 · Post by **kid_nepro_2002** » Sat Mar 13, 2010 1:17 pm

Hi Anthony,

Welcome to the forums! Check this out.....

http://www.kidnepro.com/blog/korg-m3-tu ... h-samples/

Proton

www.kidnepro.com

Anthony.karuna · Post by **Anthony.karuna** » Sat Mar 13, 2010 8:39 pm

Thank you! I figured to load samples and create a Multi sample & then make it as a program.

I had an E-MU Sampler earlier, and I just had to load a program and all the samples are aligned and ready to use. Can I not load a program/patch without having to load/assign them individually on M3? (I use CDxtract to convert samples to Akai format). Many Thanks!

kid_nepro_2002 · Post by **kid_nepro_2002** » Sat Mar 13, 2010 10:59 pm

Once you create a multi sample and then convert it to a program everything is set and ready to go. Just remember to save your programs as a PCG file and your samples as a KSC file. The KSC has to be loaded each time the M3 is booted up. The PCG will stay in memory unless you write over it.

Anthony.karuna · Post by **Anthony.karuna** » Sat Mar 20, 2010 11:24 am

Thank you so much! I was able to load samples and make it into a Program. How do I add 2 multisamples to one program and make it velocity sensitive to trigger each multisample?

kid_nepro_2002 · Post by **kid_nepro_2002** » Thu Mar 25, 2010 2:10 pm

Just look in the OSC section. There are two OSC's. Each one can have up to four multi samples - each programmed to trigger at a different velocity.