Hi
I've connected a volume-pedal to the Oasys.
Works great, and I use it mostly for organ sounds (CX-3).
In Global Mode I've set it up as CC#04,, because I want the opportunity to use it for e.g. FX balance in some programs.
How do I use this setup as a volume pedal with a HD-1 program???
I can't find the settings for it.
There's no problem with CX-3 programs!
Is it possible to set the function of the pedal directly in the combi?
Or do I have to set it in each program?
TIA
Best Regards
Ricky
HD-1 volume???
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
Mike Conway
- Approved Merchant
- Posts: 2489
- Joined: Fri Jan 28, 2005 10:44 pm
- Location: Las Vegas, Nevada
CX-3 programs assign the Foot pedal under EXPRESSION. This is per program.
If you don't want to do it per program, go to GLOBAL and change CC#04 FOOT PEDAL to CC#07 VOLUME. This will affect volume on all programs and programs within a Combi that are set to the GC (General Channel).
To set FOOT PEDAL per program, press the FILTER TAB. You will see "Output Level" near the bottom of the touchscreen. Set OUTPUT LEVEL to 0 or to a minimum level that you want. Set the AMS to FOOT PEDAL and set your INTENSITY to +99.
It there are 2 oscillators, then do this for both Filter tabs.
If you don't want to do it per program, go to GLOBAL and change CC#04 FOOT PEDAL to CC#07 VOLUME. This will affect volume on all programs and programs within a Combi that are set to the GC (General Channel).
To set FOOT PEDAL per program, press the FILTER TAB. You will see "Output Level" near the bottom of the touchscreen. Set OUTPUT LEVEL to 0 or to a minimum level that you want. Set the AMS to FOOT PEDAL and set your INTENSITY to +99.
It there are 2 oscillators, then do this for both Filter tabs.