Page 1 of 1
My Korg Kronos in PROG mode whats going on here?
Posted: Sat Jun 11, 2011 6:55 am
by taurgo Production
can someone please tell why in PROG mode in the main play part when i click on the piano, to the right you will see a setup page then under that you will see a components page. now when you are in the component page everything is in red nothing works . the same goes for setup page the only thing thats in the black is the volume, pan, octave and transpose. i can't here the piano lid position effect release time, velocity time, velocity bias, or velocity intensity. iThe stereo perspective: Player is red also.
Did i load up the right sound in the hard drive or what?
When i went on Korg us web site i watched the SG1 video and his was working fine and they was all green not red like mine
Posted: Sat Jun 11, 2011 11:16 am
by MartinHines
Removed due to incorrect info.
Posted: Sat Jun 11, 2011 5:41 pm
by danatkorg
Parameters in red are assigned to tone adjust controls.
They will all still allow editing as normal, however. Try them!
- Dan
Posted: Sat Jun 11, 2011 6:09 pm
by taurgo Production
what is tone adjust controls? and can i work them?
Posted: Sat Jun 11, 2011 6:18 pm
by cello
Down on the bottom left of the control surface (where all the manual buttons are), there's a Tone Adjust button.
Press it.
You can now use the sliders to adjust the 'tone' or program.
Posted: Sat Jun 11, 2011 7:12 pm
by taurgo Production
Posted: Sat Jun 11, 2011 7:23 pm
by MartinHines
I would suggest the following:
1) Go through the Easy Start Guide
2) Start reading the Operation Guide, reading 10 pages a day. Go through the entire book and you will be very comfortable using the Kronos.
Posted: Sat Jun 11, 2011 7:32 pm
by Kevin Nolan
OASYS owner here and don't own a Kronos yet - Dan - that sound's like an excellent new feature. To know what's assigned to Tone Adjust - very nice and _very_ useful.
Kevin.
Posted: Sat Jun 11, 2011 7:57 pm
by danatkorg
Kevin Nolan wrote:OASYS owner here and don't own a Kronos yet - Dan - that sound's like an excellent new feature. To know what's assigned to Tone Adjust - very nice and _very_ useful.
Kevin.
Thanks - it's actually on the OASYS, as well!
- Dan
Posted: Sat Jun 11, 2011 8:07 pm
by danatkorg
I think it might be worthwhile to take a little time to read the manual, as Martin suggests. In the video you change the damper noise level and then play a few notes - but the damper noise happens when you press on the damper pedal. You then reduce the mechanical noise; this is a pretty subtle noise which occurs at the end of the notes. My guess is that everything is working properly!
Hope this helps,
Dan