Advancing Combinations while sustaining?

jmmusic · Post by **jmmusic** » Mon Jul 04, 2011 9:19 pm

Is there any way to sustain a combination patch while advancing to a new combination patch? I've used Kurzweil's in the past and its been no problem. Is it possible on Tritons? Thanks!

cynkh · Post by **cynkh** » Thu Jul 07, 2011 1:36 pm

Unfortunately, no. Korg corrected this with the Kronos, however.
Depending on the effect configuration, though, you may be able to load 2 combinations into the sequencer with their configurations in tact and switch back and forth via the MIDI channel/track parameter. The effects would have to be either minimal for each combi or identical if using all or most of the available IFX/MFX slots.
Hope this helps. Cheers!

michelkeijzers · Post by **michelkeijzers** » Mon Jul 18, 2011 11:17 pm

Look at http://www.korgforums.com/forum/phpBB2/ ... hp?t=63416

It's for the M50 but I think it can be done too on a TEX.