Routing timbres to different outputs WITH FX?

laandodeman · Post by **laandodeman** » Wed Dec 19, 2012 8:42 am

I succeeded in routing different timbres to different outputs on my Kronos. This helps our sound engineer to mix my lead sound (output 3/4) seperately from the pads, hammonds and strings (output LR). But by doing that, I cannot route the timbres through the FX at the same time. Is there a solution for that?

Corgy · Post by **Corgy** » Wed Dec 19, 2012 9:31 am

Have you tried the "Bus Sel." routing that is available in "Program P8: Insert Effect" (see also Parameter Guide page 866 or 868)?

laandodeman · Post by **laandodeman** » Fri Dec 21, 2012 8:23 am

That is precisely what I do. But by using bus select on the P8 page, you can either select an FX routing OR an individual out assign. Not both at the same time.

So is there an alternative possibilty in which you can do both? Otherwise this would mean you cannot use any fx when routing a timbre to other than the LR outs.

danatkorg · Post by **danatkorg** » Fri Dec 21, 2012 7:03 pm

Each IFX has a selection for output bus.

laandodeman · Post by **laandodeman** » Fri Dec 21, 2012 7:21 pm

Thanks Dan. I get it now, you can route the timbre to the ifx and the ifx to the output. Is obvious once you see it

Teejay · Post by **Teejay** » Sat Dec 29, 2012 1:05 am

Hey, man - Mike Conway posted a really slick YT for me this afternoon, which I think explains what you need to do.. worked just great for me.

Check this:
http://www.youtube.com/watch?v=wp0Pt1bLbWU

Korg Forums

Routing timbres to different outputs WITH FX?

Routing timbres to different outputs WITH FX?

Check this...