Page 1 of 1
question on RPPR...
Posted: Thu Feb 14, 2013 1:41 am
by miden
How many bars can a single user midi pattern be to import into RPPR mode?
In other words is there a limit to the # of bars...could one use a pattern of say 16 bars in length?
Posted: Thu Feb 14, 2013 5:09 pm
by miden
Anyone????
Posted: Thu Feb 14, 2013 6:52 pm
by MarPabl
AFAIK there are no limits... but try that anyway.
Posted: Thu Feb 14, 2013 6:55 pm
by miden
Thanks Marparbl - I couldn't find an exact note of this in any of the manuals..So yeah, suck it and see hey
Cheers
Posted: Thu Feb 14, 2013 7:48 pm
by dfahrner
99, I think...
Posted: Thu Feb 14, 2013 7:56 pm
by miden
thanks DF...I thought that (99) was related to how MANY user patterns per song, not how long each one can be...
That was how I read that section, but of course, I may have misunderstood...
Posted: Thu Feb 14, 2013 8:59 pm
by dfahrner
In SEQUENCER P5:Pattern/RPPR, under Pattern Parameter, you can set the pattern length to 01 - 99 (ya got two decimal digits)...
Posted: Thu Feb 14, 2013 10:27 pm
by miden
ahhh okay - yeah I have not yet played with the "hardware buttons" on this issue yet, I have only read the section in the manual...
Thanks m8
D
Posted: Thu Feb 14, 2013 10:33 pm
by miden
I am looking at that page and I can not see any box for Pattern Parameter??
Can you advise where it can be found?
EDIT:
It's okay it is under the drop down menu, top tight...
Posted: Sat Feb 16, 2013 7:53 pm
by keekma
miden wrote:I am looking at that page and I can not see any box for Pattern Parameter??
Can you advise where it can be found?
EDIT:
It's okay it is under the drop down menu, top tight...
I did try this parameter. Set it to 5. Then I tried to copy more than one measures from a miditrack. But with the copy function you only can copy one measure. Is it possible to copy more than one measure?