Page 1 of 1
Preload KSC or load Exs individually
Posted: Mon May 20, 2013 12:39 pm
by Bertotti
Ok reading the manual trying to find out the difference between loading just the preload KSC or loading each Exs individually. But I haven't found the answer. I have been trying to use the index in the OP and Parameters guide and VNL but it doesn't tell me what each loads. Can anyone shed some light on this? I want to make sure every possible sound is loaded except the four demos. I have already checked them out. Thanks
Posted: Tue May 21, 2013 5:38 am
by MarPabl
Posted: Tue May 21, 2013 7:23 am
by Bertotti
Yes thank, you that does help, but where was all that info documented at in our available manuals? And out of curiosity what search term did you use to find it? I tried the obvious like Exs and KSC but the list was incredibly long! Seems those terms are used a lot, go figure, lol! Thanks for the link I will go dredge that one up now with a post! Thanks!
Posted: Wed May 22, 2013 4:56 am
by MarPabl
Bertotti wrote:Yes thank, you that does help, but where was all that info documented at in our available manuals? And out of curiosity what search term did you use to find it? I tried the obvious like Exs and KSC but the list was incredibly long! Seems those terms are used a lot, go figure, lol! Thanks for the link I will go dredge that one up now with a post! Thanks!
This information is not in the available guides
The terms used for search are: