Midi Editor says my KP3+ isn't connected :/

floond · Post by **floond** » Wed Jan 08, 2014 4:47 pm

Hi, I'm trying to setup my KP3+ to use it as a midi controller on Windows 7 x64 but can't get it to communicate with the midi editor.

I've installed the most recent midi driver tools from korg.com (USA_DrvTools_e(1.14_r9). Then I run the Korg MIDI Driver Setup Utility with admin rights, confirm my device is connected, and click Install. It tells me "The Device Driver has been installed properly."

Then I run the KP3+ Editor, and try to recieve data from the device, now it tells me "The Korg USB-Midi Driver is not installed...", when I check preferences it says "KP3+ (Not connected)".

Ok then, so I run the Korg Midi Driver Uninstall Utility and have to select a midi entry to delete, here it says "midi44: Korg KP3+ <Connected>"

I tried the older 1.14_r6 drivers as well with the same result.

What am I doing wrong?

Edit : The device is in Ext.Ctrl mode btw.

bradkorg · Post by **bradkorg** » Wed Jan 08, 2014 6:32 pm

Just run EzSetup64.exe again from C:\Program Files\KORG\KORG USB-MIDI Driver\EzSetup64.exe

Do this every time if next restart it doesn't recognized again.
It has to do how Windows devide the max 10 midi assignments etc.
http://www.gearslutz.com/board/music-co ... vices.html

floond · Post by **floond** » Wed Jan 08, 2014 10:50 pm

bradkorg, thank you very much for the reply! Running EzSetup64.exe again didn't help but editing registry and deleting all midi as suggested here : http://social.technet.microsoft.com/For ... -pro-64bit did wonders after a reboot.