Korg Forums

Just received a new Kronos X 88 which will take over as my new weighted controller as well as taking on the role of a synth engine for use with other controllers.

Before I can sell my Kronos 61, I need to transfer all programs and combis that I had created on that instrument into the Kronos X.

I've done some searching but haven't found a reasonably precise (guaranteed) set of steps for doing this. I have to believe that such a guide exists so I'm hoping someone can point me at the relevent document.

Thanks,
D

(Edit --- no samples, just some copied/edited Programs and a larger number of created Combis)

a SAVE ALL will provide you all programs, combi's setlists etc in one large file structure, which you can then easily load in your new Kronos

I do this almost daily to keep a recent backup of my settings on my seperate laptop

Directories with samples you need to copy as on a pc

dhjdhj wrote:Just received a new Kronos X 88 which will take over as my new weighted controller as well as taking on the role of a synth engine for use with other controllers.

Before I can sell my Kronos 61, I need to transfer all programs and combis that I had created on that instrument into the Kronos X.

I've done some searching but haven't found a reasonably precise (guaranteed) set of steps for doing this. I have to believe that such a guide exists so I'm hoping someone can point me at the relevent document.

Thanks,
D

(Edit --- no samples, just some copied/edited Programs and a larger number of created Combis)

insert a thumb drive into USB A
go to disk
select the thumb drive from the pick list
select save tab
go to upper right hand corner, select save
save your combis/programs as a pcg file and or your seq files
( to your thumb drive). Pick a file name.

When you insert the same thumb drive in your 88, select disc.
Select the thumb drive from the pick list.
You should see the file contents of your thumb/uSB drive.
Select the ' file name' and load. Test it . If you like it, save it
to your 88.

if you do a lot of keyboard splits on your 61, you would have to edit the split points on your 88

I own two and KRONOS also encounter this problem. If additional samples are not loaded - no problem. But if there are additional samples - not so simple. Need to maintain a separate file for KSC, User_Bank ... Maybe someone can detail, describe step by step procedure complete synchronization of both instruments (if downloaded third-party samples , WAV files, etc. )? KSC process save the manual covers the bad file destination USER_BANK - not described , KSC Preload action is not entirely clear. I think many users are faced with the problem of storing and loading of its work after sampling , etc.