Korg Forums

Hi, new to this forum after a long time passed browsing it

First of all i want to say thank you for the encoder and the knob issue, my ESX was going to be unusable but thank to you it's like new now

My second question is basically: I have an ESX and an EMX, and I want to put them in a box/rack but not the rack you see for the synths/ecc that is vertical, i want the ESX to stay in horizontal like in a rack for a mixer and the blue (EMX) just down there in a place where i can extract it when i play and when i leave i have my case with all inside.. basically i want a rack for a mixer with a sliding plate under it.. Hope this made sense for you..
I want to know if anyone has a tip on how to build it or where to buy it..

Sorry in advance for my english but i have lost most of what I have learned in school :/

Thanks

You're going to have to make the rack ears for the ESX yourself (shouldn't be too difficult) and sliding drawers for racks are readily available. Please post a pic when you get it done!

Blue Monster 65 wrote:You're going to have to make the rack ears for the ESX yourself (shouldn't be too difficult) and sliding drawers for racks are readily available. Please post a pic when you get it done!

Surely it will be done

I'm thinking to buy a used mixer rack for 3-4 untis and adapt it to my purposes

Cool. Will wait to see photos.

I've seen folks use drawers for keyboards. A similar 19" rack drawer might suit your purposes.