Korg Forums

Posted: **Mon Sep 22, 2014 12:01 pm**

Hi,

Although I started this post over on the Oasys forum (sadly no replies yet) , I'll raise it here coz it's likely to be relevant to the K as well.

The pads on my O are used quite a lot [for rich chords mainly under pinning lead synths and changing key signatures] and 2 of them are more or less worn out (only sounding when pressed hard--not good !).

Can I set up the NanoPad to take over not only those 2 but all the 8 pads as well ? Has anyone done this perhaps ? How is the set-up done ?

Many thanks,
Patrick

Posted: **Mon Sep 22, 2014 1:18 pm**

If I'm understanding your question correctly, I think the nanopad automatically sets the first 8 pads on itself to the 8 chords you can use from the touchscreen. It also comes with software. Check the Korg site because they may have recently came out with a new version of the nanopad. I was just browsing those MIDI controllers the other day.

Posted: **Mon Sep 22, 2014 2:22 pm**

This works on the Kronos but I'm not sure about Oasys. Can someone confirm?

Posted: **Mon Sep 22, 2014 2:29 pm**

slowtrain wrote: Check the Korg site because they may have recently came out with a new version of the nanopad. I was just browsing those MIDI controllers the other day.

http://www.korg.com/us/news/2014/090302/

not so sure about that, did not see a " Nanopad 3 " or similar basic pad controller in the press release

Posted: **Mon Sep 22, 2014 5:12 pm**

Automatically Maps on the KronosX. Don't know about the OASYS.

Posted: **Tue Sep 23, 2014 10:55 am**

I think you dont need Nanopad at OASYS because there are 8 buttons...

But Nanopad makes Kronos to OASYS

I could not play without it and you can place where you want it!

Posted: **Tue Sep 23, 2014 11:58 am**

Does the Oasys even have usb device ports?

Korg Forums

Kronos/Oasys and NanoPad

Kronos/Oasys and NanoPad