Korg Forums

Posted: **Wed Feb 04, 2015 8:22 pm**

Is this possible?

I want to have a Program with 2 AL-1's and they each go through separate fx paths not summed together until after.

I can't figure out a way without making it a Combi which I don't want to do for other reasons.

Thanks.

Posted: **Wed Feb 04, 2015 9:50 pm**

Can't be done.

Posted: **Thu Feb 05, 2015 12:39 pm**

Not sure if this would work and it is a bit limiting but I think you could use the "OSC MFX Send" Parametes to route osc 1 to MFX 1 and OSC 2 to MFX 2. At least you should get one FX per OSC.

Korg Forums

Route each oscillator to separate FX paths in Program?

Route each oscillator to separate FX paths in Program?