Korg Forums

Hi all,

Not sure if my KP3 is not working correctly. Brought second hand from ebay.

So after recording a sample the unit only plays back while i'm holding down the assigned sample button.
I was expecting it to run on a continuous loop.

Is this not the case?

Thanks for your replies

you need to complete the loop when sampling. when you stop the sampling before the loop ends, it becomes a one-shot.

Hi Riklink,
On version 2 there is up to 4 different playback modes.
If your sample is green-it's a loop and has 4,while a oneshot is red and has but 2.
-Go into edit sample mode by holding shift and tapping your sample . You may then have to press your program encoder ,before selection with same encoder.Different modes for loop are re-sync start point or not, and toggle on/off variations . One shots can't change start point.

Great thanks guys
I'll give that a go