Kronos x - Routing an effect to a fader or knob

losgrussos · Post by **losgrussos** » Mon May 18, 2015 4:14 pm

Can I rout an effect of a program sound to a fader or knob so that i can fade in the effect? And if it is possible how do I do it?

SanderXpander · Post by **SanderXpander** » Mon May 18, 2015 4:49 pm

There are a few ways but the most universal one is to set up the effect as "dry" and assign RT knob to a certain amount in the dry/wet AMS field. +100 is fully wet but you can use any amount. Make sure the control surface is set to RT/Karma.

losgrussos · Post by **losgrussos** » Mon May 18, 2015 6:09 pm

thanks, it worked.

michelkeijzers · Post by **michelkeijzers** » Tue May 19, 2015 9:41 am

Note: this also works for switches (SW1, SW2), you can set the amount between dry/wet for OFF an ON (set initial value as OFF, and the difference as the modulation value).