Posted: Mon Jul 20, 2015 4:23 pm
How to you program a sample to fire from a switch? I do not see where this could be done?
But, you can add a zone *below* the sample, and make that blank as well.buschmann wrote:This works very well, actually - though only "upwards" (start on A#0, stop on B0, retriggers on A0) since samples - at least to my knowledge - keeps playing under the original key. There is no buttom key, only a top key.SanderXpander wrote:3. Set up the sample in a much smaller key range, then set the timbre to monophonic and hit any key outside of that keyrange to stop your sample. (I think, I haven't tried this)
Great!