Microkorg Cutoff Knob Not Working. Next Step?

Discussion relating to the Korg MS2000, MS2000B & microKorg.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
EJJoseph
Posts: 1
Joined: Sat Sep 08, 2018 10:47 pm

Microkorg Cutoff Knob Not Working. Next Step?

Post by EJJoseph »

Hi, I got a Microkorg not far back for a pretty decent price, but it may have been stored for a while. Everything seems in working order except for the cut off filter.

Turning the knob seems to do nothing, so I took it apart to have a look myself. I've taken some pictures that I'll post here.

- https://imgur.com/a/5pwrJvW

My concern is the little bit of rust on one of the connector pins in picture 2.

I'm experience at soldering but haven't put it into practice on commercial hardware, so I wonder if it's worth getting a replacement and re-soldering the piece. The cutoff filter is a pretty critical knob. I can't re-write my own patches without it. What are my options? Could I potentially ruin the synth by soldering a new piece on?

The part I would need is a Rotary potentiometer.

Any advice would be great.

- EJ
OpAmp
Platinum Member
Posts: 1180
Joined: Fri Jun 07, 2013 10:26 pm
Location: Brussels, BE

Post by OpAmp »

Hi,

There seems to be plenty of space around the pot. So it should be fine to desolder the old one solder a new one.
Maybe first measure the pot with a multi meter. Removing the old solder and putting new one, may help as well if the pot is still ok according the measurement.

Good luck.
microKORGXL, Kaossilator Pro, monotribe, SQ-1, volca fm, Kross 88 BK
Alesis SR18, Akai Miniak, Fender Strat, Line 6 Spider II 112, Zoom MS-50G
slug
Senior Member
Posts: 371
Joined: Fri Aug 03, 2007 2:59 am

Post by slug »

Yep just replace the pot.
Derpancakes
Posts: 45
Joined: Wed Jun 18, 2014 7:33 pm

Post by Derpancakes »

My friend got a secondhand MK without checking on it, and ended up with the same problem. It's an easy replacement job, but finding the part was kinda tough. I recall one synth parts website having it for around $7, then I got it installed within an hour. Just make sure you remember how you got everything apart.
Post Reply

Return to “Korg MS2000 & microKorg”