Use Arduino to redirect midi channels to the Korg Volca Samp

mmaisterrena · Post by **mmaisterrena** » Mon Sep 28, 2015 1:44 am

Volca Simple,this video shows how to redirect midi channels to the Korg Volca Sample using an Arduino
https://www.youtube.com/watch?v=zcMHnB5qIcQ

Steinberger · Post by **Steinberger** » Mon Sep 28, 2015 4:12 am

Nicely done! The same challenge exists with the new Electrbes. I arrived at the same solution with the MIDI Solutions Event Processor Plus. I posted a link to the Arturia post in this site's Electribe sub forum. The MS EPP is limited to 32 tasks so it doesn't have enough room to process all 16 BSP pads as well as clock and transport control messages. Looks like this could easily handle mapping all 16 drum sequencer pads of the BSP to the Electribe though.

BSP 1-8 > E/S2 9-16
BSP 9-16 > E/S2 1-8
MIDI Note #60

Now we have two solutions to a problem Arturia won't make go away.

Gongrats and Thanks!

mmaisterrena · Post by **mmaisterrena** » Tue Sep 29, 2015 12:36 am

Thanks, I didn't know that product existed, a little pricey but it seems more straight forward, although i learn a ton while making this thing. BTW I'm more inclined to blame Korg for this problem than arturia, but sure, either of them could easily remedy this.

mmaisterrena · Post by **mmaisterrena** » Thu Dec 31, 2015 12:33 am

Updated the code and now you can play pitched notes
watch the video here:
https://www.youtube.com/watch?v=WYGxZFbxsSg