Hello All,
I'm trying to re-arrange PADs on my PA300. I backed up all my pads before I started. Now I'm trying to restore the complete Local bank 7 to Local bank 5 & it just won't do it. If I try loading one pad at a time if works fine.
Question is why won't the whole bank load at a time ?
Any ideas/clues would be great. Of course I have unchecked the protect tabs in the global settings.
Thanks & Best Regards
Ewart
PA300: Backed up PADs not being loaded
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Hello All,
Found a solution ! It seems that 'LOCAL' PADs were not getting loaded directly so I loaded them to a USER bank (which loaded fine) & then copied them to the LOCAL bank.
I know this may not be needed by all but just in case someone comes across this issue, hope this tip helps.
Thanks & Best Regards
Ewart
Found a solution ! It seems that 'LOCAL' PADs were not getting loaded directly so I loaded them to a USER bank (which loaded fine) & then copied them to the LOCAL bank.
I know this may not be needed by all but just in case someone comes across this issue, hope this tip helps.
Thanks & Best Regards
Ewart