Disable program name?

trak5comp · Post by **trak5comp** » Wed May 12, 2021 6:48 pm

Is there a way to disable the program name that shows over the waveforms? It would be nice if it appeared initially, and then went away. I've looked through all of the global options and don't see an option to do so. I've seen it disabled on YouTube videos though.

It would be helpful when I'm turning the Shape button, and others, so I can see what it looks like. But the program name/number covers it up.

RobustAmerican · Post by **RobustAmerican** » Wed May 12, 2021 10:19 pm

In global edit page 7 set "Parameter Display" to normal and "Oscilloscope" to enable. With these settings, the name disappears after a few seconds and only the scope remains.

trak5comp · Post by **trak5comp** » Thu May 13, 2021 12:01 pm

Well, there it is then. Thank you

MRNUTTY · Post by **MRNUTTY** » Thu Jun 03, 2021 2:43 pm

Notes on scope:
- scope is synced to VCO1 - VCO2 and digital are free running.
- scope is directly after filter stage.