|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
mymusic42 Junior Member
Joined: 29 Mar 2006 Posts: 93
|
Posted: Wed Dec 14, 2011 8:53 pm Post subject: Audio Input Question |
|
|
I think I did this years ago with my Triton, so I think it is possible but I can't remember how. I am on 418/419 of the parameter guide but still can't get it.
my kronos is is midi'd up to a sound module. i'd like that module's audio out to go back into the kronos. i have it all hooked up. when the module is going to an external mixer i hear the sound. when i take the cable out of the mixer and put in in the kronos input 1, i don't hear any sound. any thoughts/direction how to make this work?
thanks |
|
Back to top |
|
|
markn Full Member
Joined: 15 Nov 2011 Posts: 206 Location: Germany
|
Posted: Wed Dec 14, 2011 9:54 pm Post subject: |
|
|
-- _________________ Kronos88, Kronos 2/61, Dave Smith Pro-2, Minimoog Voyager, MacBook Pro, LogicProX - and a whole bunch of older stuff...
Last edited by markn on Wed Dec 14, 2011 9:56 pm; edited 1 time in total |
|
Back to top |
|
|
markn Full Member
Joined: 15 Nov 2011 Posts: 206 Location: Germany
|
Posted: Wed Dec 14, 2011 9:54 pm Post subject: |
|
|
Go to Global Mode P0: Basic Setup - Audio
Set Bus Select of input 1 and 2 to L/R
Set Pan Input 1 to left - Input 2 to right (for stereo)
Turn up the level of both channels do the desired value
That´s it...
And, of course, refer to Kronos Parameter guide, Page 759
Regards
markn _________________ Kronos88, Kronos 2/61, Dave Smith Pro-2, Minimoog Voyager, MacBook Pro, LogicProX - and a whole bunch of older stuff... |
|
Back to top |
|
|
mymusic42 Junior Member
Joined: 29 Mar 2006 Posts: 93
|
Posted: Thu Dec 15, 2011 3:29 am Post subject: |
|
|
Thanks I got it working |
|
Back to top |
|
|
michelkeijzers Approved Merchant
Joined: 08 Feb 2007 Posts: 9113 Location: Netherlands
|
Posted: Thu Dec 15, 2011 9:46 am Post subject: |
|
|
I disabled the audio inputs. Last time while rehearsing I had quite some noise. I thought it was an amp from the guitar player (I always blame guitar players, sorry jk) ... however I found out later at home the input gains knobs had been turned, probably by moving the Kronos in or out its case.
Since I don't use the inputs (at least not while rehearsing) I switched them off globally and now the output is completely without noise _________________
Developer of the free PCG file managing application for most Korg workstations: PCG Tools, see https://www.kronoshaven.com/pcgtools/ |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|