Korg Forums

I use arpeggios... usually three or four notes per beat, in a descending pattern... this makes for a really nice breakdown in the song as well, with a bit of knob twiddling:)

I would guess the problem is with the freq range of your monitors...

Midi dump is shift-6 according to the manual, but I dont have a bcr, so you'll have to try it out for yourself!

I'm fairly sure you can damage the input by driving it. But I've never really looked into it. With regards to the constant-ness, I always used to turn the arpeggiator on, 100% gate, and latch it. increase the 'release' level if you have to to smoothe it out, and make sure the EG retrigger parameter ...

Hmm sounds weird...
Have you tried using a different amp than you usually do? Or different headphones?
Does this happen with the headphones plug or the L/R plugs? Have you tested it with both, because if it only happens in one it is possibly a loose connection.

Have you tried using some (very gentle) ring modulation? That usually helps me. I also like a healthy dose of phaser. Everyone's taste for EP's is different, so there is very little solid advice I can give you sorry... My personal setup, which I use in a jazz band, is to use the EP sound on my ...

Well of course contacting korg is the obvious answer, why didn't I think of that:) I suppose I thought it was too minor an issue, but now that you mention it, I will contact them today

Thank you for the advice

OK this is an amazing ability of the microkorg I only discovered today, after have this synth for almost 9 months! With this trick, you can get three oscillators, all modulating eachother, layer cross modulation with two ring modulators for example. You can also achieve 8pole filters, double ...

Well this is my first post here at Korg Forums, and as with everyone who makes their first post, I have a problem. The Edit Select 2 pot on my microkorg has issues... The knob has come loose off the axel, to the extent that I can pull it off. I screwed the secret screw as tight as I could screw, but ...