Korg Forums

Look at page 333 to 335 in the English User's Manual

As karmathanever say "What made you buy it"
Dont waste ouer time

awafula, have you find out what the probblem was

The CD can only be heard from the output L/R NEVER from output 1/2.
The MP3 can both

Cheers
Kjeld

It is a Analog problem. Are you using Output L/R or 1/2 :?: You have to open the Keyboard. Behind the CDROM drive, there are a Audio Cable there are going to the Mainboard (I think). It is a 4 pole cable (White/Shield/Shield/Red) lenght=230mm. Find this cable and check if one of the plugs are lose ...

It is an over 3 years advertisement
Maby it is allready sold

Cheers

Kjeld

Very, very nice. You are playing very good with a good performance also a nice video record. Where are your location More like this for inspiration thanks

NO

foxy: The only thing you have to tell are: What is the leg number for the "Gnd" in the din. plug, the rest are not so important (you can completely SHORT all pin in the din. plug without damage the KB:wink: AND all is "ANALOG" like a "DOOR BELL" touch, the "DIGITAL" point is inside the KB, so NO ...

I think it is possible. You can send the signal from Cubase Out into the input 1 "and only no. 1" in the KB (remember to set. the Micr. sw. in pos. line In 1+2, and not Micr. pos.) Then you have to go into Global/Audio Output/Audio In, and then you have to change the Output from "Voice Processor" to ...

I think it have been a bad contact in the switch, because you never use it :wink: It can have been an OP-AMP in the Mic. line there are the probs. , but "NEVER" the vol. poti :wink: If you never use Mic. "In", then let the Sw. stay in pos. "1" 8) If you still have probs., you have to by a new Board ...

Try to set the Micr. SW. to position 1 and not Micr. (on the backpanel)
Try to place your output cable in 1 and 2 (instead of L/R)
I mean you have the PRO version
Im sitting and study the Scematic Diagram and try to help you

Kjeld

Have you tryed to set all slider to "0"
Is the noise in both left and right channel
Are the noise also in the headphone output

Kjeld

Why are you starting a new thread
What was your solution
What have you done wrong before
Tell us, tell us, tell us
and who the H... are Steve M
Kjeld