Hi,
I was wondering how you can change Multisets on the x50 using midi. e.g. if, when playing back on Sonar a song which uses Multiset 001, how do you get Sonar to switch whichever the current Multiset is showing to 001?
I'm fine changing Bank and Program messages, but can't see a comparable set up for the Multiset numbers.
The manual says send a Song select message, but I'm not sure how to do that with Sonar.
Thanks for any advice on this.
Robert
Changing Multisets by midi
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Changing x50 multisets by midi
Hi, yes! Still haven't worked it out! The manual says it responds to a Song select message - my impression (perhaps misguided) would be that, when you say opened your song in Sonar, it would open the correct multiset at the same time.
I even set a song in Sonar to send a sysx message back to the x50, with a dump of the multiset setting...and, did it change?....no such luck.
Its not a disaster, I name the multisets and rotate the dial.
But, should changing multisets by midi really be so difficult??
Resignedly, Robert
I even set a song in Sonar to send a sysx message back to the x50, with a dump of the multiset setting...and, did it change?....no such luck.
Its not a disaster, I name the multisets and rotate the dial.
But, should changing multisets by midi really be so difficult??
Resignedly, Robert