analog input - FIXED!

KrzysiekK · Post by **KrzysiekK** » Fri Nov 30, 2007 10:24 pm

Hello,

I received my TEX88 today (used). I tried plugging in microphone (input 1) and did all settings according to instructions : Global -> Input/sampling -> set inputs to analog, and set proper level for Input1, set BUS(IFX/Indiv) to L/R. I get absolutely no signal (not even a noise). I have a suspiction that something's wrong with input setting on the rear - MIC/LINE switch seems is functioning correctly but the level knob was pushed inside so it was very hard to move. After I maganed to move it finally, it jumped out slightly and now it is moving quite easily but with no MIN/MAX limits and still no audible effect; if I push it slightly, I get MIN/MAX limits but still no effect. Could someone tell me how should the level knob should look like in working unit?

Thanks!
Best regards,
Krzysiek

bquarrie · Post by **bquarrie** » Sat Dec 01, 2007 8:24 am

Hi.

By the sounds of this it's not just the knob that's broken but also the circuit connected to it. You need to get it serviced asap.

On a working unit the knob would stop turning when you've reached the max or min volume. It doesn't gets pressed in, either...

KrzysiekK · Post by **KrzysiekK** » Sat Dec 01, 2007 12:20 pm

bquarrie wrote:Hi.
By the sounds of this it's not just the knob that's broken but also the circuit connected to it. You need to get it serviced asap.

Thanks, I will pass it to repair.

Best regards,
Krzysiek

KrzysiekK · Post by **KrzysiekK** » Sun Dec 02, 2007 4:21 pm

Before I send the unit to repair, I want to look inside myself to check analog inputs. Is there any instruction on TEX88 disassembly?

One more question - assuming analog inputs are working OK and external source (MIC) is connected, in PROGRAM -> P0 -> Sampling there is "Recording Level [dB]" view. Should I see activity of these levels as soon as I set Input to "Analog" and set level to 127 or there is something more required?

Thanks

Best regards,
Krzysiek

KrzysiekK · Post by **KrzysiekK** » Wed Dec 05, 2007 8:43 am

Analog inputs now are working. That was Alps 10k double potentiometer which was damaged - 2 pins came off the cover of potentiometer, most probably because of hitting it from outside; happily the contacts were recoverable by soldering. Btw. Korg could place the potentiometer in safer place.

Best regards,
Krzysiek