Problems with PadK... -This device cannot start. (Code 10)

Dj Radi · Post by **Dj Radi** » Fri Dec 28, 2007 10:46 am

Hi.
I got the padkontrol yesterday!

And installed all the software and everything was done the right way.
But I get this massage @ "device manager" that says:

"This device cannot start. (Code 10)

Click 'Check for solutions' to send data about this device to Microsoft and to see if there is a solution available."

So I did, and I got the answere that the device is up to date and so one...
The PK showes no light on the dispay and dosn't start at all...
What is the problem and what do I do? :'(

Thanks for any answers and help in advanced!

subVert · Post by **subVert** » Fri Dec 28, 2007 7:34 pm

Just a guess, but do you have the padkontrol plugged into a USB hub? If so, does the hub has it's own power. If the PC seems to be sensing the padkontrol but shows no lights then maybe it's not getting enough power via usb.

Or if you have it plugged in directly, it's possible that your USB port might not be supplying power.

I guess a good test would be to try to borrow a power adapter for it to see if it comes to life.

Dj Radi · Post by **Dj Radi** » Fri Dec 28, 2007 7:53 pm

subVert wrote:Just a guess, but do you have the padkontrol plugged into a USB hub? If so, does the hub has it's own power. If the PC seems to be sensing the padkontrol but shows no lights then maybe it's not getting enough power via usb.

Or if you have it plugged in directly, it's possible that your USB port might not be supplying power.

I guess a good test would be to try to borrow a power adapter for it to see if it comes to life.

Thanks for answere. I have it plugged right to the PC,
but I have a powred ubs-hub that I can try to connect it to.

(I have VISTA)

Dj Radi · Post by **Dj Radi** » Tue Jan 01, 2008 4:25 pm

It worked!

But now I have another problem... :/
It dosn't show up anywere, not in Live or FL, etc..
What is the problem? What do I do?

subVert · Post by **subVert** » Tue Jan 01, 2008 4:57 pm

Under Live 7 I just added it as a control surface. I can't remember how I did it because I was just following one of the live tutorials when I set it up.

Dj Radi · Post by **Dj Radi** » Tue Jan 01, 2008 5:15 pm

It would be nice if anyone could tell me how to do it

Dj Radi · Post by **Dj Radi** » Tue Jan 01, 2008 6:46 pm

I still get the same message in "Device Manager".:

"This device cannot start. (Code 10)" ...
As writen in post 1. But now there is light and all that fancy S*** :@
But i want to use it