Sometimes when i turn on my Z4 it just freezes, and shows 0 on display.
When i restart it everything works normally.
In some cases sends verry strange noises through channels that are set to firewire audio even if no software is running.
Again restart resolves the problem.
Hope that this new update will resolve this issues.
Must say that i have no noise issues and except this my Zero works great.
Anyone with same problems?
Korg ZERO 4 Startup Problem
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
- Posts: 12
- Joined: Thu Mar 20, 2008 3:24 am
-
- Posts: 12
- Joined: Thu Mar 20, 2008 3:24 am
Version 1.6 updated
Ok Guy's
This is how I was getting the problem
I tried changing computer's and installed the drivers again.
1. I checked my firmware and downloaded the new one from the internet.
2. I tried using the updater, I followed everything and changed it to
midi in 2 and midi out 2
3. I choose the 1.6.vsb file
4. when I was doing update, halfway through, the screen on KORG would
go dark and I would receive the following error
5. receiving error(timeout)
There was another step that I had missed
THIS WAS THE MAIN PROBLEM.
1. Before powering your Zero, Press and hold "Keep" and "ch 2" below
the display (SYS.U will start blinking). Once this start's blinking than
you would go to the first step on the top.
****You can't update your firmware if SYS.U is not blinking on your screen..
And now Enjoy your Zero4
This is how I was getting the problem
I tried changing computer's and installed the drivers again.
1. I checked my firmware and downloaded the new one from the internet.
2. I tried using the updater, I followed everything and changed it to
midi in 2 and midi out 2
3. I choose the 1.6.vsb file
4. when I was doing update, halfway through, the screen on KORG would
go dark and I would receive the following error
5. receiving error(timeout)
There was another step that I had missed
THIS WAS THE MAIN PROBLEM.
1. Before powering your Zero, Press and hold "Keep" and "ch 2" below
the display (SYS.U will start blinking). Once this start's blinking than
you would go to the first step on the top.
****You can't update your firmware if SYS.U is not blinking on your screen..
And now Enjoy your Zero4