can you scroll through scenes? like the xone 3d wheels allow

djcarpentier · Post by **djcarpentier** » Wed Apr 16, 2008 7:32 pm

just wondering if its possible to scroll through scenes vertically in ableton using the zero 4 or zero 8? the A&H xone 3d jog wheels apparently do that. i dont want to have to use a mouse to select a clip, then use the midi controls to trigger them. any answers would be helpful as this will be one of the main reasons for buying it. thanks

Dj-Grobe · Post by **Dj-Grobe** » Thu Apr 17, 2008 9:13 am

You can just map one endless knob for make that, very easy.

subterFUSE · Post by **subterFUSE** » Thu Apr 17, 2008 2:53 pm

Yes. Just as Grobe says, you map a rotary encoder knob to Ableton.

When you enter MIDI map mode on Ableton, look at the bottom of the scenes column. You will see up and down arrows, and a box with a number next to that. Simply click that box and turn a rotary encoder knob. That's it.

djcarpentier · Post by **djcarpentier** » Fri Apr 18, 2008 4:59 pm

great. thanks guys. also curious as you both have a zero 8, what else are you using with it? was thinking of getting a padkontrol for a few extra buttons and knobs. does it work well with other midi equipment?

subterFUSE · Post by **subterFUSE** » Fri Apr 18, 2008 5:44 pm

I am not using anything else at the moment. But I would like to have more buttons for launching clips. I don't think I want to have 2 controllers, though.

McQ714 · Post by **McQ714** » Fri Apr 18, 2008 11:43 pm

Because Korg does not have Vista 64-bit drivers at the moment for the Zero mixers, I have my Zero 4 running through the padKontrol's Midi port. It works extremely well. I also have a XioSynth and all 3 get along just fine. Two on USB obviously and the Zero on MIDI. But if you're looking for more buttons and knobs, I just read a review in Future Music about the Livid Instruments Ohm Controller, and I gotta say.. I'm impressed. But for a MIDI controller, it's not cheap.