Realtime controls in "B" Modus on MicroX

Ganlog · Post by **Ganlog** » Sun May 25, 2008 2:30 pm

Hey guys. Seem to be very stupid (maybe because of going out long yesterday night) but in the manual and also otherwise I can't find out how to change the assignable controls 1-4 in "B" mode?

I can see on the display Knob "B" 1-4 on the bottom of the menu but don't know how to jump to the changeable parameters.

Can any one help?

Thanx.

Grees Ganlog

Bigs · Post by **Bigs** » Sun May 25, 2008 8:59 pm

Do you mean the 'Controls' page (at the far right) of the 'Arp/Control' section (which kan be reached using the menu button)?

Ganlog · Post by **Ganlog** » Mon May 26, 2008 7:09 am

hello bigs

No there's nothing about the arp. My english isn't very clear maybe. When I selected "B" in the realtime controls section on the right side of the micro x I just want to define which parameters are changed when I use the control knobs 1-4 .

Unfortunately I don't know how I can put a picture into this post. Do you understand now?

Thanx for the answer...

Grees Ganlog

Bigs · Post by **Bigs** » Mon May 26, 2008 2:36 pm

Ok, step by step then:

- Choose a program
- Press 'menu'
- Choose 'Arp/controls'
- Press Page+ two times to go to the 'controls' tab
- Use the clickpoint and/or wheel to change the settings

For combinations it's the same, only you have to flick through some more pages.

Ganlog · Post by **Ganlog** » Mon May 26, 2008 7:23 pm

hey bigs thanx a lot. I found out now and makes me happy. I found it in the manual too now.

grees Ganlog