How is Rotor made on the XMS2 board ?

Flemming M · Post by **Flemming M** » Wed May 28, 2008 7:02 pm

I have just get the XMS2 organ board from Musitronic. It is a great organ board and funny. But is there anyone here who now how the Rotoreffekt work. When I puch the Joystick momently Up in Y the sound Pitch and there are not a Rotor on/off. You are welcome to guide me on a privat mail if it is a long story too change this and perhaps all the single organsounds !

wittid · Post by **wittid** » Thu May 29, 2008 6:42 am

Hi Flemming, in some performances it works with the joystick - in other ways it´s a crossover between 2 samples slow and fast.

You´ve to use a expression pedal or use the fader in the assignable mode (not volume) and then you can make the crossover between the samples.

cu
Detlef

Flemming M · Post by **Flemming M** » Thu May 29, 2008 7:01 am

Good morning Detlef. Can you send me - perhaps privat - the guide for the controller bethween the shift for a Slow organ voice - and the same organ voice samlpe fast.

Is it the shift from Upper 1 - Upper 2 ?

karmathanever · Post by **karmathanever** » Thu May 29, 2008 9:14 am

The shift from slow to fast leslie effect is configured all within the one SOUND. This is a very effective and clever configuration. You are really switching multisamples (all within the one SOUND) with a nice crossover so that you do not lose the volume of the sound.

If you look at the SOUND detail you will see how the joystick has been configured.

Cheers

Pete

wittid · Post by **wittid** » Thu May 29, 2008 11:36 am

Flemming M wrote:Good morning Detlef. Can you send me - perhaps privat - the guide for the controller bethween the shift for a Slow organ voice - and the same organ voice samlpe fast.

Is it the shift from Upper 1 - Upper 2 ?

Hi Flemming, i doesn´t have any manual about this - sorry.

cu
Detlef