stereo output on Korg TR

RANTARAVE · Post by **RANTARAVE** » Sun Apr 13, 2008 2:53 am

how do i do a stereo output on a Korg TR my headphone out works fine stereo but when i plug my TR into a mixer the right chanel doesn't have any sound only the left channel

Fatalmasterpiece · Post by **Fatalmasterpiece** » Sun Apr 13, 2008 2:59 am

You should run two cables to the mixer.

RANTARAVE · Post by **RANTARAVE** » Sat Apr 26, 2008 2:49 am

i did but the right channel doesn't produce any sound

Stephen · Post by **Stephen** » Sat Apr 26, 2008 2:40 pm

If this is true for all programs, and Combis, it may need service, but be sure to check the obvious, like Mixer channels, cables, etc.
Best of luck.

Ethenmar · Post by **Ethenmar** » Sun May 25, 2008 4:42 pm

I have the same problem. I check all connections and cables but the R output sounds very little.

Ethenmar · Post by **Ethenmar** » Tue May 27, 2008 12:30 pm

Fatalmasterpiece · Post by **Fatalmasterpiece** » Tue May 27, 2008 12:32 pm

I know it is a bit obvious but try plugging the right into the left to ensure it is not the channel on your mixer.

Ethenmar · Post by **Ethenmar** » Tue May 27, 2008 3:13 pm

Hi Fatal!

I verified all connections , with 2 different mixers and the Le but doesn't sound. I have this problem with the phones output too.

Thank you for your comment.

Regards!

Fatalmasterpiece · Post by **Fatalmasterpiece** » Tue May 27, 2008 4:54 pm

Alright,

I was just downstairs doing some recording and I van verify that for some reason, one of the lines is actually quieter. I have no idea why.

To solve this, I looked at my meter bride, or whatever you use to monitor your levels and adjust the two channels until they are the same. For me it wasn't any more than a 2-5 db difference.

Ethenmar · Post by **Ethenmar** » Thu Jun 26, 2008 10:54 am

+480 reads, no solutions

X-Trade · Post by **X-Trade** » Thu Jun 26, 2008 12:30 pm

i've noticed this but on a much smaller scale.. when i pull the volume control on the TR down, I can still hear a little on the left, but nothing on the right. I've been through several mixers and this is always the same. so it would appear that the left is slightly louder.
Maybe its to do with the volume control? is it just a normal potential divider?

Stephen · Post by **Stephen** » Thu Jun 26, 2008 12:56 pm

I'm not near my TR, and maybe this is too obvious but, did you check the PANNING under the PROGRAM tab?
You could adjust there.
HTH

X-Trade · Post by **X-Trade** » Thu Jun 26, 2008 12:59 pm

maybe korg needs to have a pan adjust in global mode