Using SW1 or 2 to alter arp pattern?

NeoTriton · Post by **NeoTriton** » Thu Jul 10, 2008 11:02 pm

Does any one know if it's possible for me to assign a switch to swap between 2 arp patterns in a program?

I have 2 arp patterns programmed and I want to swap them during performance in a single program. Another option might be to make a combi and assign one program arp A then the same program with arp B on it and zone them?

Any thoughts?

nikola81 · Post by **nikola81** » Fri Jul 11, 2008 1:15 am

You could try and copy them into a user patterns side by side, open arp page and switch them with inc dec buttons.

NeoTriton · Post by **NeoTriton** » Fri Jul 11, 2008 8:48 pm

I've already tried that and it works however I'd much rather use one of the 2 switches.