Program sound dies in Sequencer Mode

[soulidstate]

Hi,

I am wondering if anyone of you experiences my problem. A Virus TI Snow is attached to my M3 and often times I get sounds from the Snow for tracks1-4. I usually make loops using Patterns of my own and put them in tracks afterwards.There are times when playing back the pattern with the virus patch, it loops continuously even if I stop the playback. The only way to shut if off is by going to the main page of the SEQ then play and stop the sequencer. What is very weard is that if for example I have a piano track on t5, when I go the T5 and play it, the track doesn't play the piano. The VU meter doesn't indicate that there is sound playing. The only way to get out of this mess is to reboot the M3.

This is a very annoying problem. Any comment or suggestion?

[mf_blues]

I haven't had this problem but I was wondering have you updated the software to the latest version and are you assigning the output to both or either internal or external for the midi control. Also is the TI connected with both midi in and out if so you may have some loop created.

I may be talking a load of B*!!*ck$ but it's the best I can suggest.

cheers

[soulidstate]

I haven't had this problem but I was wondering have you updated the software to the latest version and are you assigning the output to both or either internal or external for the midi control. Also is the TI connected with both midi in and out if so you may have some loop created.

I may be talking a load of B*!!*ck$ but it's the best I can suggest.

cheers

Hi Mart,

OS is latest which is V2. I always assign EXT2 to tracks 1-4 which are for the TI and since the TI works only from Midi channels 1-4 and my problem is with Track 5 then I would assume it's got nothing to do with the TI but let me investigate more if it's got something to do loop.

Thank you for you response.
Regards,
Em