Smartmedia EMX-1 question...

chethedog(absent) · Post by **chethedog(absent)** » Mon Jun 29, 2009 4:50 am

Finally got myself a card. I understand some say it's unecessary for the EMX-1. Just overwrite the pre-loaded patterns! BUT I was getting close to full capacity. Wanted to dump the files onto my computer, and without midi capabilities right now ~ here i am.

So via smartmedia, I now have a .emx file copied to my computer.

Is this file, ALL patterns on the EMX, or just ONE?
Do I have to go through and save each individual pattern?

My intention is to save all my patterns, and wipe the EMX-1 clean.
I'd hate to wipe it while only having saved one pattern!
And i'm not in the mood to go and save ALL of them individually, if i don't have to.

Hmmm. I guess this is a newbie post. Been playing around for a while though. Any help would be much appreciated.

Take care,
Adrian.

Droo · Post by **Droo** » Mon Jun 29, 2009 5:38 am

If you used "SavAll" through global menu, than you saved all

.
You can wipe out your emx.
You can check it by deleting some of the patterns and load your previous backup.

djrain9 · Post by **djrain9** » Sat Aug 01, 2009 1:54 pm

so then the load one pattern option is to reload a pattern you've jacked up then wrote?

I really thought save all meant save all one pattern, but noticed when I did the load all, I lost a few tracks and they were replaced with presets

I've saved 30 or so patterns using save all, but obviusly have done something wrong here ..

now I am trying to load one pattern b.05 into a differnt spot..
and this is not working.