Im taking the micro kontrol to good will.

Discussion relating to Korg Controller products.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
Jay-
Posts: 13
Joined: Tue Jun 30, 2009 1:24 am

Im taking the micro kontrol to good will.

Post by Jay- »

Weird, it works until I put a midi signal into it then it shuts down.
If I update the firmware it will say "Timed out"

I thought it was stuck in update mode so I took it apart to look for a battery I could reset.

It boots up with windows just fine and gets power.
The Korg USB driver installs but is weird.

Should it get power and light up in cubase? It's installed as a generic device but no midi passes!

I used Midi OX to test it and when I transmit audio it immediately shuts down.

O well,

:evil:
User avatar
DjRavix
Posts: 44
Joined: Mon Jun 22, 2009 10:41 pm

Post by DjRavix »

Try hooking it up by use of midi (Not trough USB)

see:
http://www.korgforums.com/forum/phpBB2/ ... hp?t=44368
I think it has to do with this Driver bug as well
PC Hardware:
Intel Q6600 On GA-P35-DS4, 4GB, 74 GB/640 GB/1 TB/250 MB Hard drives
DC-FW800 PCIe, GF 8800 GTS512, 2x X222W
Audio HW:
828MK3, 61SL MKII, Virus, AirFX, iNano, M1 Active Mk2
Audio SW:
Cubase 5.5.1, Sound Set Synthesizers, HALion Symphonic Orchestra, The Grand 3, HALion Sonic, KLC-AE07, Predator, SubBoomBass, RP-Verb, VPS: MBSC, VPS:Metrum, FF Bundle, VES1, VTS1, Oxford Inflator, Sylenth1, Z3TA+, VMS:MBC, RP-Delay
Jay-
Posts: 13
Joined: Tue Jun 30, 2009 1:24 am

Post by Jay- »

Thanks,

I put batteries in and use the USB and it wont start.
Only paid $30 but it sure is a trick little all in one device.
Post Reply

Return to “Korg Kontrol49, microKontrol, padKontrol, nano and K series controllers”