play back.

[orion]

is it possible to have a play back of MicroKORG on synth part 1 of the EMX and still have the drum parts or other synth parts playing? if so how?

cheers.

[woodswalker]

is it possible to have a play back of MicroKORG on synth part 1 of the EMX and still have the drum parts or other synth parts playing? if so how?

cheers.

Hi! I got my electribe in december so I'm still learning too. As far as I can tell, you can connect another instrument cable to the 'audio play thru' jack. but all it will do is send the signal straight thru the electribe and into the amp. So it is just for if you don't have 2 amp inputs or a mixer. I believe you can also tempo sync your electribe to the other synth/sequencer, using auto-bpm. I haven't tried this yet.

So you can play or run your other instrument while still running your electribe normally. However I haven't been able to apply any electribe effects (delay etc) to the external synth sounds.

I also don't think you can run your external synth thru one of the synth pads on the electribe. If I'm wrong, let me know!
good luck,
Laura

[xmlguy]

The AudioIN+CombFilter Osc type lets you route the audio through a synth part, and then onto the FX, if you wish.

[woodswalker]

The AudioIN+CombFilter Osc type lets you route the audio through a synth part, and then onto the FX, if you wish.

I have never been able to make that work. I can't detect any effect in my external synth.

I also have a question, can you apply 2 different effects to different synth parts? Like delay on one and phaser on #2?

Pretty much when I use an effect, it gets applied to the whole pattern.

laura

[orion]

woodswalker: you can use midi to run it through the sequencer.

[woodswalker]

woodswalker: you can use midi to run it through the sequencer.

what would you run thru MIDI? the audio in?