How to copy an arp pattern in user pattern??

Rishat · Post by **Rishat** » Tue Mar 02, 2010 3:35 pm

Hay folks.. How do I copy a preset arp pattern in initial (empty) pattern?? For instance as we can change the parameter of a program and write that to an empty/initial user bank. I want to copy a preset pattern and write the pattern using the empty slot for arp and then edit the copied pattern as desired. Please assist.. I read the manual and some part of UG but nothing found...

Love you all guys..!!

Rishat · Post by **Rishat** » Wed Mar 03, 2010 4:31 pm

So nobody is able to give me the answer...

No one???

Rishat · Post by **Rishat** » Wed Mar 03, 2010 6:03 pm

Say yes or no but say something guys..

mocando · Post by **mocando** » Wed Mar 03, 2010 7:32 pm

Rishat, is a common behavior on forums that a topic gets no answers because several possible reasons:

a. The answer is too obvious and can be found by a simple forum search
b. Is too complicated and the one knowing the answer is not willing to take the time to answer it
c. Is such a joke that you are asking the impossible OR
d. The person who knows the answer haven't read the thread yet

I believe your question is cataloged as letter "d", so have patience and eventually it will be answered.

Rishat · Post by **Rishat** » Thu Mar 04, 2010 9:32 pm

Yes yes... Tomorrow I am going to play it live on stage.. and I still dont know whether it is possible to copy a preset arp pattern to user pattern or not... I supposed to use a preset pattern to edit and play live but I think that is not gonna happen..

Thats why I was so excited to get the answer Martyn... Sorry bro...

StudioMan · Post by **StudioMan** » Thu Mar 11, 2010 12:14 am

Well, there are at least 3 ways I can think of.

Try this.

Open the combi the ARP is in you want, save to an unused combi. Edit away!

Mike

X-Trade · Post by **X-Trade** » Thu Mar 11, 2010 1:38 am

The OP is talking about the actual arp pattern editing in global mode, not simply the programs and combis that use the arps.

I can't remember how it was done on my TR, but I would suggest you simply try it and see - go to edit one of the preset patterns, and then choose to save/write/whatever, it should let you choose what slot to save it to, just like when writing a Program or Combi.

Does the M50 actually distinguish from User and Preload patterns? I thought you could just edit and write over them anyway, in which case it would the the same as editing and copying a user pattern.