PCG sounds

Ahmed Jaber · Post by **Ahmed Jaber** » Sat Jun 12, 2010 1:59 pm

Hi Forums!
I have many PCG sounds in my triton ex,can i used these (PCG files) in my new Korg M3?.
If not how can i used these files in M3?.
Thanks.

Nor · Post by **Nor** » Sun Jun 13, 2010 7:23 pm

TrEx and M3 don't share the same architecture, so you have to copy by hand each parameter to your new M3. You can' then load Triton PCGs to the M3.

Ahmed Jaber · Post by **Ahmed Jaber** » Mon Jun 14, 2010 6:13 pm

Thank you Nor,but can you explain more what do you mean copy by hand each parameter.
If i have a file with many PCG sounds do you mean i must copy sound after sound or what?
Thank you again.

BasariStudios · Post by **BasariStudios** » Mon Jun 14, 2010 6:33 pm

Yes you have to copy them one by one, not the sounds but the Parameters
in each sound, some of them might sound better some worst...i had to do
a lot of my sounds like that in these sets:
http://www.basaristudios.com/id37.html
http://www.basaristudios.com/id16.html

Synastikki · Post by **Synastikki** » Mon Jun 14, 2010 7:22 pm

The different synth engine of the two (HI-synthesis vs. EDS) causes the pcg:s to be different so they cannot be transferred between the two. If you want a sound from Triton Extreme to M3 you'll have to go through all the parametres of the sound (waveforms, filters, EG and so on...) and copy them from one to another...

Nor · Post by **Nor** » Tue Jun 15, 2010 9:04 pm

Ahmed Jaber wrote:Thank you Nor,but can you explain more what do you mean copy by hand each parameter.
If i have a file with many PCG sounds do you mean i must copy sound after sound or what?
Thank you again.

As NEDIM said, you copy each parameter from one synth to the other. Turn on TrEx and M3 copy from the screen of TrEx to the screen of M3.

I know it's a lot of hard work but you don't any other choice.