When i add a synth part in part edit, like a bass sound(M1-bass), it sounds fine in keyboard mode.
But when i play it back it sounds like a high pitch click, not a bass at all.
What gives ?
Once you find the sound you want in part edit mode it should sound the same when you play it back.
Synth Oscillator is set to PCM-WS.
Please help, this is driving me nuts.
Electribe MX: Synth parts don't sound correct in playback
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
yeah
I ran into this same problem, using noise I would play it and record it, but when I would play it back there was nothing there...
I tried the noise on a different synth button, nothing still.. then I went in and turned the swing off, and a few other settings just to see if it would change it, then I could here the sound..
not the exact answer your looking for, but there is a button or knob or setting that will change this.. and once you find it.. youll probably forget what you did 2 days later.
I tried the noise on a different synth button, nothing still.. then I went in and turned the swing off, and a few other settings just to see if it would change it, then I could here the sound..
not the exact answer your looking for, but there is a button or knob or setting that will change this.. and once you find it.. youll probably forget what you did 2 days later.