Volume of a timbre in combi mode

jankofron · Post by **jankofron** » Thu Aug 26, 2010 8:53 am

Hi all, I would like to setup a combination and to increase the volume of a single timbre in the combi mode via one of the knobs while playing. Is this somehow possible? I found just a master volume control, however, I have two timbres sounding at a time and want to "boost" just one of them. I thought abou application of a filter, but have not figured out any reasonable solution... Thanks for any hints

. Jan

jankofron · Post by **jankofron** » Thu Aug 26, 2010 8:56 am

Sorry, I forgot to mention I have TR 76.

X-Trade · Post by **X-Trade** » Thu Aug 26, 2010 12:51 pm

Solution would be the same on all triton models:

- Set one knob to 'expression' or 'volume' (expression goes from zero up to mixer set 'volume' level, whereas 'volume' completely overrides the mixer setting).
- Then set up the Timbre MIDI Filter pages such that only your timbre you want to control will respond to that knob.

jankofron · Post by **jankofron** » Thu Aug 26, 2010 1:10 pm

Thanks a lot!

calois1 · Post by **calois1** » Sat Nov 03, 2012 2:48 am

exactly what do you have to do to get the volume pedal to bring in the strings and leave the piano alone in a combi?

calois1 · Post by **calois1** » Sat Nov 03, 2012 2:49 am

i should have said I have a triton Le