tri-pbs software issue!!!!!

[gorkymate]

Hi,
I've download software 2.41 for non V3 users and install TRI-PBS option.
There it was, working, putting my samples in Trinity and after while...problems comes along
I see that I got S bank in program but is this normal or not?
Now my Trinity is freezing after I power on unit and start to switch beetwen A and B bank it freezes!!! Why?!?! Btw, it worked like 20 minutes ok and then it started to foll arround = freeze
Is there any advise for problem???

[Timo]

I've download software 2.41 for non V3 users and install TRI-PBS option.

I see that I got S bank in program but is this normal or not?

Do you not have a Solo-TRI board installed?

Now my Trinity is freezing after I power on unit and start to switch beetwen A and B bank it freezes!!! Why?!?!

This is normal after you've just installed the PBS-TRI option. Mine did the same.

You have to do a hardware reset on the Trinity after installing the PBS-TRI.

1) Firstly make sure you back up all current PCG data from the Trinity to floppy disk or similar.
2) Turn off Trinity.
3) Turn on Trinity while holding both ENTER and number 0 (zero) keys. This will reset the Trinity. Your Trinity should recognise the PBS and everything should work properly after this point.
4) Restore PCG data by reloading your PCG backup.

[gorkymate]

I don't have Solo board....its' not Trinity plus...I don't know why I got S bank in software...
Maybe there is older version of software?
I didi all the things that you said but still it freezes as I switch from bank A to B and that' it...freeze point.
After 0 + Enter when power on synth on screen writes ''Moss version 07''
???
And still same thing after reset stil blocks or freeze after changing banks-
I'm I going crazy or?

[synthjoe]

I understand you have no solo board, but are you sure that there's no MOSS board, either? I don't know this kind of failure, but maybe that's what you get when installing the V2 OS on a machine with MOSS board. Maybe it would be worthwhile installing V3 OS if you don't want to take your synth apart to check for sure that nothing is connected to the MOSS/Solo connector.

Where did you get the PBS board from? Are you sure it is a flawlessly working specimen?

[gorkymate]

..yeap, pretty sure that there is no MOSS, it would be greatto have it but
...

[synthjoe]

Okay then...
However, loading V3 OS migth be an idea anyways, just to try something different. OS V3 should run without either MOSS or Solo board, shouldn't it? It is just that you cannot use Solo with V3 OS, I think. Just an idea to try.

[gorkymate]

..yeah, I guess I could try that...
Something tells me that these two chips have very good reason to make my life not boring..they are missing from board, there is only plastic frame where you can put those chips inside.
I don't have them,...so, if this is the main reason, then nothing will help.

[synthjoe]

Those should be plain (more or less) memory chips for banks C and D (plus 64 extra slots in M or S), so I don't know... A search on the forum turned up this, you might want to check it for further information or in order to get the extra chips, even though I would be surprised if that was at the root of your problem.

Where did you get the PBS expansion? Would you mind sharing the information? I have already considered adding it to my second Trinity, but they are rather difficult to find.