Change Pattern instantly - no queue

Discussion relating to the Korg Electribe products.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
LamptonWorm
Posts: 23
Joined: Mon Feb 21, 2011 7:35 pm

Change Pattern instantly - no queue

Post by LamptonWorm »

Hi,

I'm sending the EMX a program change message (from an MPC 500) -- this puts the target pattern in the queue so it comes in on time next loop around.

Is there a way to switch off the queue/timing so it starts the pattern as soon as it receives the program change?

Even outside of using the program change message over MIDI, simply press play on a pattern then select a new pattern, it doesn't switch immediately.

Typically I know it's nice to keep it in time but I wondered if I can switch that behaviour off.

Cheers,
LW.
Post Reply

Return to “Korg Electribe”