using combi in sequencer mode

arteen · Post by **arteen** » Wed Jun 01, 2011 9:20 am

Pls help...i copied combi to my sequencer to make a song using the pre recorded combi on the M3. then when i want to add other tracks it dosent work ...like when i want to record track No10 there is no sound ...how can i add more tracks to the copied combi on the sequencer...pls. help

alland · Post by **alland** » Wed Jun 01, 2011 3:59 pm

Most probably you just need set up proper MIDI channel to added track.
When you copy Combi to SEQ (using Enter+Rec/Write) then all MIDI channels are copied to SEQ as they were in Combi mode.
Usually these channels are 01 to tracks that play immediately when you play keys and possible 02-something higher on tracks that are used by KARMA. Tracks that are unused in Combi get usually the track no as MIDI ch (i.e track 14 can get MIDI ch 14 etc).

So in order to add tracks in SEQ you either:

a) if you want play/record this added track along with other tracks set its midi ch to the same value that your other "real time" tracks are (usually 01)

b) if you want record new track independently then look SEQ P3 what MIDI track it uses and on SEQ page set recording that Track.

c) Also ensure on P3 that Status is set INT and not Off (it gets status "off" if timpre is set to "mute" on combi you are copying from)

arteen · Post by **arteen** » Thu Jun 02, 2011 6:34 am

i will try it , thanx will come back to you once it's done ...thank you again

arteen · Post by **arteen** » Thu Jun 02, 2011 10:11 pm

thanks it went well ..thanks for your help and i have another question i've already posted...i need now to save my sequencer as a wave to my usb how can i do so ...thanx again