I have searched for specifics in both the oper guide and param guide but the info is vague at least to me. I've tried doing it myself but with no results.
What I am trying to do is bounce portions of some of my midi tracks (not the whole song and not all tracks) into audio tracks to free up the midi for both polyphony and more fx. (I am really trying to do everything in the Kronos rather than Kronos and my DAW).
I'm pretty sure the Kronos can do this and I'll probably feel real stupid when I find out how to do it.
Any help would be greatly appreciated.
Resample from sequence play
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
Mike Conway
- Approved Merchant
- Posts: 2481
- Joined: Fri Jan 28, 2005 10:44 pm
- Location: Las Vegas, Nevada
This is an old video I did, but the concepts can be applied to what you are doing. Instead of using multiple song slots, you can do what you need on one song.
Multiple Combi Recording
Please note, at the 5:55 mark I talk about turning other track levels down. If you are recording through the L/R outs, like in the video, then this is how you will isolate the tracks you want recorded. Turn the Metronome level down or off, also.
There are other ways to route a track. If you aren't using the Master or Total FX, you can route after your IFX to a Record Bus (1 - 4) and set the Audio track source to the corresponding record bus. This will record the sound and the IFX. on the IFX tab, if effects are Chained, go to the last effect in the chain and set its output bus to one or two (if in stereo) of the Record busses.
Multiple Combi Recording
Please note, at the 5:55 mark I talk about turning other track levels down. If you are recording through the L/R outs, like in the video, then this is how you will isolate the tracks you want recorded. Turn the Metronome level down or off, also.
There are other ways to route a track. If you aren't using the Master or Total FX, you can route after your IFX to a Record Bus (1 - 4) and set the Audio track source to the corresponding record bus. This will record the sound and the IFX. on the IFX tab, if effects are Chained, go to the last effect in the chain and set its output bus to one or two (if in stereo) of the Record busses.