Any ideas on how to create a thin, hollow sounding pad- something glassy? I've been working with VPM Moded sines + ring moded sines, put through a high pass with resonance to give it that hollow low end, but I've had little luck.
Any ideas for specific harmonics/tuning to use for the VPM/Ring for a really nice glassy tone?
Glassy Pad Ideas
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Glassy Pad Ideas
Current: MS-20 Mini, Minilogue, SY77
Past: Korg R3, Volca Bass, X50, Mg Slim Phatty, Rld Gaia SH-01, Yamaha TX81Z
Have my freebie granular plug-in: https://www.muffwiggler.com/forum/viewt ... p?t=192886
Past: Korg R3, Volca Bass, X50, Mg Slim Phatty, Rld Gaia SH-01, Yamaha TX81Z
Have my freebie granular plug-in: https://www.muffwiggler.com/forum/viewt ... p?t=192886
-
CharlesFerraro
- Platinum Member
- Posts: 955
- Joined: Sat Feb 06, 2010 10:15 am
- Location: California
http://www.file-upload.net/download-376 ... d.rdp.html
The low end is a MKXL preset called glassy that I layered with a top following the advice of you and zalo.
The hollow low is a sine and square. Minimal waveshaping on the sine and +12 on the square. They're running through a velo sensitive lowpass with static 40% reso. Some chorus and delay are applied.
My patch is a tri with minimal vpm mod depth and harmonics. -12 semi square at <50% volume with ring mod. Parallel filters with EG3 taking care of boosting the reso to around 70% with sustain after peaking at 127. LFOs to cutoffs/amps/int. Applied limiter to tame the reso spikes.
Sounds good but i made it without EQ or drive, lots to tinker with. No MFX/mod seq/arp used.
The low end is a MKXL preset called glassy that I layered with a top following the advice of you and zalo.
The hollow low is a sine and square. Minimal waveshaping on the sine and +12 on the square. They're running through a velo sensitive lowpass with static 40% reso. Some chorus and delay are applied.
My patch is a tri with minimal vpm mod depth and harmonics. -12 semi square at <50% volume with ring mod. Parallel filters with EG3 taking care of boosting the reso to around 70% with sustain after peaking at 127. LFOs to cutoffs/amps/int. Applied limiter to tame the reso spikes.
Sounds good but i made it without EQ or drive, lots to tinker with. No MFX/mod seq/arp used.
paypal.me/CharlesFerraro