combining programs

[kenrdot]

Is it possible to combine two programs that are already complete or do you have to start from scratch on the second one thanks for any help.I want to combine an EP1 program with an Mod 7 string program

[michelkeijzers]

Is it possible to combine two programs that are already complete or do you have to start from scratch on the second one thanks for any help.I want to combine an EP1 program with an Mod 7 string program

If you mean with 'combine' using a combi which uses 2 programs (the EP1 and MOD7), no problem at all.

- Select an empty combi.
- Go to the most important program
- Select from menu: copy from program
- Check IFX-es all and others
- Ok
- Go to the other program
- Select from menu: copy from program
- Uncheck everything except IFxs - all used
- OK

You only have to check if the MFX/TFXs are correct, if not you could copy them manually and redirect settings a bit.

[kenrdot]

I want to put two Exi sounds together in one program without doing it from scratch

[michelkeijzers]

I want to put two Exi sounds together in one program without doing it from scratch

It would be strange if this would not be possible. I don't have a Kronos by hand, but I would expect a function like 'Copy from program osc/engine whatever'.

[Broadwave]

Select the program you want to start with, then:

Tap the COMMON tab
Tap the PROGRAM BASIC menu tab (top right corner)
Tap COPY EXi OSCILLATOR
Select to the Program/Oscillator you want to copy to EXi 2
Tap OK.

Job done... But remember that any effects from the program you are copying will not be carried across - it's only the basic program settings that are copied. Any effects will have to be inserted manually.

[kenrdot]

Thank you all so much for your help the people on this forum are +1