connecting Kronos to my Pa3x

Mmayassi · Post by **Mmayassi** » Sun Dec 25, 2011 5:07 am

Hi

I am trying to connect cronos to my pa3x so I get use of the speakers that I am using for my pa3x.

The only way i was able to do so is to take the line out from Kronos to the line in in my pa3x, and I have to change the output routing to go from the line rather than the MIC. which means I will not be able to use the Mic or the voice processor while I am connecting an external device to my pa3x.

it is really disappointing !!! any one knows a better solution. I am not using any external sound system. I am using the speakers that were built by korg for the pa3x.

Mmayassi · Post by **Mmayassi** » Wed Dec 28, 2011 12:07 pm

Any reply ???

AntonySharmman · Post by **AntonySharmman** » Wed Dec 28, 2011 2:03 pm

At rear audio panel you connect L-R Kronos outputs and at MIC your
microphone and by default mixed sum of them can be delivered from
L-R output channels and Kronos volume regulator will be its own master
volume.
I've had used that configuration with excellent results.

I don't own PAS (waste stuff for me), so I can't confirm that output routing
but normally should have the same behavior.

Mmayassi · Post by **Mmayassi** » Wed Dec 28, 2011 7:26 pm

didn't get it !!! if I connect Kronos to Mic in Pa3x how can I use the Mic for singing .

AntonySharmman · Post by **AntonySharmman** » Wed Dec 28, 2011 8:03 pm

Mmayassi
My Friend there is a third black jack MIC ,where you insert your microphone
Kronos is inserted to R & L inputs !
Its very simple just observe carefully rear input panel !