Hello There,
I'm a recent purchaser of the Korg Micro Station and loving it so far. I've been playing around with the Arpeggio Pattern grid, programming my own patterns, but I don't seem to be able to change the velocity of the individual notes I program in. There is a velocity parameter below the grid which I can change for each note I have created, but this doesn't seem to effect the volume of the individual notes in any way. I have read the manual but can't seem to find what this could be. Does anyone have any idea?
Any help appeciated!
Thanks
Neil
[/img]
Arpeggio Pattern Velocity Problem
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Editor seems to have some problems?
Hi Neil
I also just bought the microSTATION and getting to know it. I have a similar problem that I can change the length of additional notes with the editor but playback is incorrect for any new notes added to the original version.
But I can change the velocity beat by beat and that works fine on my editor (on Macbook Air) - have you moved the small yellow triangle underneath the correct column of the grid? It seems you have to change each beat individually and there is no obvious way to set a default value for any of the notes to be added?
Best wishes
Mike Mahalo
I also just bought the microSTATION and getting to know it. I have a similar problem that I can change the length of additional notes with the editor but playback is incorrect for any new notes added to the original version.
But I can change the velocity beat by beat and that works fine on my editor (on Macbook Air) - have you moved the small yellow triangle underneath the correct column of the grid? It seems you have to change each beat individually and there is no obvious way to set a default value for any of the notes to be added?
Best wishes
Mike Mahalo
HI Mike,
yes I had moved the little triangle, its okay though i worked out what the problem was. I needed to change the the patch I was using's velocity sensitivity (i think the setting was called velocity intensity or something along them lines)up as it was set to zero and therefore different velocities were not effecting the amp with the original setting.
Not too sure the answer to your problem though i'm afraid
yes I had moved the little triangle, its okay though i worked out what the problem was. I needed to change the the patch I was using's velocity sensitivity (i think the setting was called velocity intensity or something along them lines)up as it was set to zero and therefore different velocities were not effecting the amp with the original setting.
Not too sure the answer to your problem though i'm afraid