how to set up midi controller to change parameters on screen
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
how to set up midi controller to change parameters on screen
How do i set up a midi controller to change the parameters on the screen in program mode. For example if i wanted to assign the lowpass filter for the ms20 in program mode to be controlled from a knob on my mpc, and see the knob move on screen.
-
- Full Member
- Posts: 197
- Joined: Fri Apr 06, 2012 11:12 pm
- Location: Victoria, BC, Canada
- Contact:
-
- Platinum Member
- Posts: 1118
- Joined: Wed May 25, 2011 9:24 am
- Location: Manchester UK
- Contact:
Re: how to set up midi controller to change parameters on sc
To set up a controller on the MS20 (for example, Filter Freq) right click "Voltage Controlled Lowpass Filter" text above the on-screen knob and select "Learn" then move the control knob on your MPC that you wish to associate with that parameter - an onscreen message will pop up asking you to confirm. The right click again and deselect "Learn".Hayer wrote:How do i set up a midi controller to change the parameters on the screen in program mode. For example if i wanted to assign the lowpass filter for the ms20 in program mode to be controlled from a knob on my mpc, and see the knob move on screen.
The knob on your MPC will now change the parameter on the editor and send the appropriate sysex command to the Kronos.